The flags argument to Tcl_TraceCommand indicates when the trace procedure is to be invoked. It consists of an OR'ed combination of any of the following values:
Whenever one of the specified operations occurs to the command, proc will be invoked. It should have arguments and result that match the type Tcl_CommandTraceProc:
typedef void Tcl_CommandTraceProc( ClientData clientData, Tcl_Interp *interp, const char *oldName, const char *newName, int flags);The clientData and interp parameters will have the same values as those passed to Tcl_TraceCommand when the trace was created. ClientData typically points to an application-specific data structure that describes what to do when proc is invoked. OldName gives the name of the command being renamed, and newName gives the name that the command is being renamed to (or NULL when the command is being deleted.) Flags is an OR'ed combination of bits potentially providing several pieces of information. One of the bits TCL_TRACE_RENAME and TCL_TRACE_DELETE will be set in flags to indicate which operation is being performed on the command. The bit TCL_TRACE_DESTROYED will be set in flags if the trace is about to be destroyed; this information may be useful to proc so that it can clean up its own internal data structures (see the section TCL_TRACE_DESTROYED below for more details). Because the deletion of commands can take place as part of the deletion of the interp that contains them, proc must be careful about checking what the passed in interp value can be called upon to do. The routine Tcl_InterpDeleted is an important tool for this. When Tcl_InterpDeleted returns 1, proc will not be able to invoke any scripts in interp. The function of proc in that circumstance is limited to the cleanup of its own data structures.
Tcl_UntraceCommand may be used to remove a trace. If the command specified by interp, cmdName, and flags has a trace set with flags, proc, and clientData, then the corresponding trace is removed. If no such trace exists, then the call to Tcl_UntraceCommand has no effect. The same bits are valid for flags as for calls to Tcl_TraceCommand.
Tcl_CommandTraceInfo may be used to retrieve information about traces set on a given command. The return value from Tcl_CommandTraceInfo is the clientData associated with a particular trace. The trace must be on the command specified by the interp, cmdName, and flags arguments (note that currently the flags are ignored; flags should be set to 0 for future compatibility) and its trace procedure must the same as the proc argument. If the prevClientData argument is NULL then the return value corresponds to the first (most recently created) matching trace, or NULL if there are no matching traces. If the prevClientData argument is not NULL, then it should be the return value from a previous call to Tcl_CommandTraceInfo. In this case, the new return value will correspond to the next matching trace after the one whose clientData matches prevClientData, or NULL if no trace matches prevClientData or if there are no more matching traces after it. This mechanism makes it possible to step through all of the traces for a given command that have the same proc.